Jeeps are the perfect cars for adventurers and those who love to explore in the wild. Jeep Wrangler JKs have been around since 2007, but many owners of these vehicles find that they do not have a lot of light when it is dark out. When you’re deep into the woods and need to see what’s ahead or off-roading at night, this can be a major problem! Luckily, there is an easy solution: installing halo lights on your Jeep Wrangler JK! In this article I will show you how to install these lights with step by step instructions.
How to Install Halo Lights on Jeep Wrangler JK: Step by Step Instructions:
Step One: Purchase your halo lights kit from a reputable supplier. You can find these kits at most auto parts stores or online retailers, and they are relatively inexpensive to purchase. If you plan on doing this project with other people in order to save time, then it is best if everyone buys their own set of halo light bulbs so that the bulbs are interchangeable.
Step Two: Disconnect your Jeep Wrangler JK’s battery by using the provided key in order to avoid an electrical fire or shocks from touching any wires during this project.
Step Three: Remove your Jeep Wrangler JK’s headlight from the car. This is usually done by turning counterclockwise and pulling it out of the mounting bracket. If you have a high beam or low beam, then separate those two pieces to make this process easier.
Clean all connections that will be coming into contact with any wires. This is important to avoid any electrical connections that could lead to a malfunction or fire.
Step Four: Connect the halo light wires and place them into their corresponding slots on your Jeep Wrangler JK’s headlight bracket, then connect the other end of each wire to one side of the halogen bulb socket. Remember: high beams go in slot A, and low beams go in slot B.
Step Five: Gently tighten the two bolts on your Jeep Wrangler JK’s headlight bracket to secure all connections. Make sure not to over tighten these nuts or else you run the risk of damaging wires inside of them. Place the halogen bulb into their corresponding slots for high beam lights or low beam lights, then tighten the bolts. Reattach your Jeep Wrangler JK’s headlight to its mounting bracket by turning clockwise and pushing it in place.
Step Six: Turn on both of your high beams or low beams for a few seconds, turn them off, with otherthen turn those same headlights back on again. If you see any type of smoke or smell something burning, then you may have a malfunction near your battery. Turn off the car and disconnect it for good measure if that happens.
Enjoy installing halo lights on your Jeep Wrangler JK! You can now see much better when driving at night, camping in the woods, or hitting those dirt roads throughout the year!
Conclusion
In conclusion, installing Halo lights on a Jeep Wrangler JK is fairly easy and the cost of the kit is well worth it. The installation will take some time but this was expected from such an intricate project. It can be done in one day if you have all your tools ready to go before beginning. If not, plan for two days of work. The results are worth it and the halo lights will make your Jeep stand out from all other Wranglers.
Add Comment